bluesoleil dongle

scottrose · Newbie Joined: 03 Jul 2006 Posts: 3

hello-

i recently purchased a bluesoleil bluetooth dongle for my laptop so that I could connect with my palm tungsten e2. unfortunately, I only found out later that this was not compat. with salling clicker. are there any ways around this and/or are you planning to support bluesoleil in future releases? i'm trying to decide if it's worth investing in another of these silly dongles...

dgaust · Newbie Joined: 03 Jan 2006 Posts: 6

You can use the instructions at this link

Widcomm Bluetooth
[i]EDIT: Link removed; I cannot allow links to cracked software in my forums - BlueSoleil will be natively supported in a future version - Best, Jonas[/i]

scottrose · Newbie Joined: 03 Jul 2006 Posts: 3

thank you - but which instructions? there seem to be a lot of links and instructions on this page :)

dgaust · Newbie Joined: 03 Jan 2006 Posts: 6

Posts 4 and 6. Install the drivers downloaded from the link in post 6 and then follow the steps outlined in the download from post 4.

sunaymehta · Newbie Joined: 12 Mar 2006 Posts: 2

Download the New WIDCOMM DRIVER 5.0.1 and install the same after removing all previous versions of IVT DRIVER or Bluesoliel and the clicker works fine...

dhc · Newbie Joined: 14 Dec 2006 Posts: 4

Instructions on how to do this can be found here: http://tinyurl.com/yjhqu7 (or by searching for "salling bluesoleil" on Google, 3rd link down, Techmundo)

The drivers can be found by searching for: "Widcomm 5.0.1.801 bluetooth drivers" (1st link, driverguide.com).

Hope this doesn't breach forum protocol, it's just I was so delighted to get the clicker working and I wanted to share :)